|
Three-Way Bass Reflex Car Speaker System
(120-1725) Features
Faxback Doc. # 38063
Your Optimus Three-Way Bass Reflex Car Speaker System is designed to give
you clean sound with powerful bass. The system is ideal for rear-deck
mounting.
To get the best sound from your speakers, please read all of these
instructions carefully for the proper wiring and mounting procedures.
BEFORE YOU BEGIN
We recommend that you connect your autosound system to the speakers before
you mount them so you can test the speakers and the wire connections. When
you verify that everything works properly, turn off your autosound system
and mount the speakers.
NOTE: If you are unsure about the following installation process, we
recommend that you have a professional install the speakers.
mounting position. Then determine the center of the mounting position.
3. Drill a hole 1/4-inch wide in the center of the mounting position.
4. Attach the bolt to the bottom of the speaker cabinet and secure the
bolt using a Phillips screwdriver.
5. Position the speaker cabinet on the mounting surface by inserting the
bolt through the drilled hole.
6. Underneath the mounting surface, place the washer over the bolt. Then
thread and tighten the wing nut until the speaker cabinet is secure.
Three-Way Bass Reflex Car Speaker System
(120-1725)
Specifications
Faxback Doc. # 15674
Crossover Capacitor
Size................................................................5x11 mm
Capacitance.....................................2.2 micro Farad, 50 V (B/P)
Speaker Size: ........................................... 3 1/2-inch woofer
2-inch midrange
1 1/2-inch tweeter
Barium Magnet Weight: ............................................. 5.36 oz
Power Handling Capacity: .................................... 30 Watts each
Impedance: ......................................................... 4 ohms
Frequency Response: ....................................... 150 - 20,000 Hz
Sensitivity: ........................................................ 90 dB
Specifications are typical; individual units may vary. Specifications
are subject to change without notice.
(br/km-02/19/1997)
Audio Connection Information
(120-Series)
Plug/Male 2 Ch. System
Faxback Doc.# 19994
+----+--------------+---------------+------------+------------------------+
|Pin |
|
|
|
|
|
|
|No. | WIRE COLOR | WIRE SPECS. | LABEL
REMARK
+----+--------------+---------------+------------+------------------------+
| 1 | WHT/BLK
| AWG #20
| 2P CORD
| FRONT L- | STRIP SOLDER
|
|
|
|
|
|
+----+--------------+---------------+------------+------------------------+
| 2 | GRY/BLK | FRONT R- |
+----+--------------+---------------+------------+------------------------+
| 3 |
+----+--------------+---------------+------------+------------------------+
| 4 |
+----+--------------+---------------+------------+------------------------+
| 5 | BLACK | AWG 206 | GROUND | 6.3mm r FORK TERMINAL |
+----+--------------+---------------+------------+------------------------+
| 6 | ORG/WHT * | | DIMMER | STRIP SOLDER
+----+--------------+---------------+------------+------------------------+
| 7 | PINK/WHT * | | PHONE MUTE |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
|
|
|
|
|
|
|
"
|
"
"
|
| 8 | WHITE
| AWG #20
| 2p CORD
| FRONT L+ |
|
|
|
|
|
|
"
+----+--------------+---------------+------------+------------------------+
| 9 | GRAY | FRONT R+ |
+----+--------------+---------------+------------+------------------------+
| 10 |
+----+--------------+---------------+------------+------------------------+
| 11 |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
|
|
|
|
|
|
|
RED
| AWG #20
|
| +12 V TO | 250/ 1A FUSE & 24M/M |
| IGNITION | TRANS STRIP SOLDER |
+----+--------------+---------------+------------+------------------------+
| 13 | YELLOW
|
|
"
| +12 V TO | 250/ 1A FUSE STRIP
| BATTERY | SOLDER
|
|
|
|
+----+--------------+---------------+------------+------------------------+
| 14 | DARK BLUE/ |
"
| AMP REMOTE | WIRE BANDING &
|
|
|
|
|
|
|
|
|
|
|
|
|
WHITE
|
|
|
|
| TURN ON |
| 500mA MAX |
|+12 V OUTPUT|
TUBE HEATING
|
|
+----+--------------+---------------+------------+------------------------+
* May or may not be present depending on features of individual radios.
(2CH/4CH SWITCHABLE UNIT)
+----+--------------+---------------+------------+------------------------+
|Pin |
|
|
|
|
|
|
|No. | WIRE COLOR | WIRE SPECS. | LABEL
REMARK
+----+--------------+---------------+------------+------------------------+
| 1 | WHT/BLK
| AWG #20
| 2P CORD
| FRONT L- | STRIP SOLDER
|
|
|
|
|
|
+----+--------------+---------------+------------+------------------------+
| 2 | GRY/BLK | FRONT R- |
+----+--------------+---------------+------------+------------------------+
| 3 | GRN/BLK | REAR L- |
+----+--------------+---------------+------------+------------------------+
| 4 | VIO/BLK | REAR R- |
+----+--------------+---------------+------------+------------------------+
| 5 | BLACK | AWG 206 | GROUND | 6.3mm r FORK TERMINAL |
+----+--------------+---------------+------------+------------------------+
| 6 | ORG/WHT * | | DIMMER | STRIP SOLDER
+----+--------------+---------------+------------+------------------------+
| 7 | PINK/WHT * | | PHONE MUTE |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
"
"
|
|
"
"
|
"
|
"
"
|
| 8 | WHITE
| AWG #20
| 2p CORD
| FRONT L+ |
|
|
|
|
|
|
"
+----+--------------+---------------+------------+------------------------+
| 9 | GRAY | FRONT R+ |
+----+--------------+---------------+------------+------------------------+
| 10 | GREEN | REAR L+ |
+----+--------------+---------------+------------+------------------------+
| 11 | VIOLET | REAR R+ |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
"
|
|
"
"
|
| 12 |
RED
| AWG #20
|
| +12 V TO | 250/ 1A FUSE & 24M/M |
| IGNITION | TRANS STRIP SOLDER |
|
|
+----+--------------+---------------+------------+------------------------+
| 13 | YELLOW
|
|
"
| +12 V TO | 250/ 1A FUSE STRIP
| BATTERY | SOLDER
|
|
|
|
+----+--------------+---------------+------------+------------------------+
| 14 | DARK BLUE/ |
"
| AMP REMOTE | WIRE BANDING &
|
|
|
|
|
|
|
|
|
|
WHITE
|
|
|
| TURN ON |
| 500mA MAX |
|+12 V OUTPUT|
TUBE HEATING
+----+--------------+---------------+------------+------------------------+
* May or may not be present depending on features of individual radios.
4 Chnl Unit
+----+--------------+---------------+------------+------------------------+
|Pin |
|
|
|
|
|
|
|No. | WIRE COLOR | WIRE SPECS. | LABEL
REMARK
+----+--------------+---------------+------------+------------------------+
| 1 | WHT/BLK
| AWG #20
| 2P CORD
| FRONT L- | STRIP SOLDER
|
|
|
|
|
|
+----+--------------+---------------+------------+------------------------+
| 2 | GRY/BLK | FRONT R- |
+----+--------------+---------------+------------+------------------------+
| 3 | GRN/BLK | REAR L- |
+----+--------------+---------------+------------+------------------------+
| 4 | VIO/BLK | REAR R- |
+----+--------------+---------------+------------+------------------------+
| 5 | BLACK | AWG 206 | GROUND | 6.3mm r FORK TERMINAL |
+----+--------------+---------------+------------+------------------------+
| 6 | ORG/WHT * | | DIMMER | STRIP SOLDER
+----+--------------+---------------+------------+------------------------+
| 7 | PINK/WHT * | | PHONE MUTE |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
"
"
|
|
"
"
|
"
|
"
"
|
| 8 | WHITE
| AWG #20
| 2p CORD
|
|
|
|
"
+----+--------------+---------------+------------+------------------------+
| 9 | GRAY | FRONT R+ |
+----+--------------+---------------+------------+------------------------+
| 10 | GREEN | REAR L+ |
+----+--------------+---------------+------------+------------------------+
| 11 | VIOLET | REAR R+ |
+----+--------------+---------------+------------+------------------------+
|
"
"
|
|
"
|
|
"
"
|
| 12 |
RED
| AWG #20
|
| +12 V TO | 250/ 1A FUSE & 24M/M |
| IGNITION | TRANS STRIP SOLDER |
|
|
+----+--------------+---------------+------------+------------------------+
| 13 | YELLOW
|
|
"
| +12 V TO | 250/ 1A FUSE STRIP
| BATTERY | SOLDER
|
|
|
|
+----+--------------+---------------+------------+------------------------+
"
| AMP REMOTE | WIRE BANDING &
|
|
|
|
| TURN ON |
| 500mA MAX |
|+12 V OUTPUT|
TUBE HEATING
+----+--------------+---------------+------------+------------------------+
* May or may not be present depending on features of individual radios.
5-Pin DIN
FRONT
+---------+--------------+
| Green | Right (+) |
+---------+--------------+
| White | Right (-) |
+---------+--------------+
| Brown | Left (+)
+---------+--------------+
| Gray | Left (-)
+---------+--------------+
| Red | +12 V Power |
|
|
+---------+--------------+
REAR
+---------+--------------+
| GRN/BLK | Right (+)
+---------+--------------+
| WH/BLK | Right (-)
+---------+--------------+
| BR/BLK | Left (+)
+---------+--------------+
|GRAY/BLK | Left (-)
|
|
|
|
+---------+--------------+
+---------+--------------+
| Orange | S.P.L.
+---------+--------------+
| Black | Ground
+---------+--------------+
|
|
| Red w/ | Memory
| White | Backup
|
|
+---------+--------------+
LN-03/04
|