MEDIA CONVERTER TECHNICAL SPECIFICATIONS
Environment
Temperature:
Humidity
Altitude
0-40°C (32° to 104° F )
10-90%, non condensing
0-10,000 feet
Minneapolis, MN 55344 USA
10Mb/s Ethernet™ Single Mode/Multimode
Slide-In-Module Media Converter
C/F-SM-MM-05
Warranty
Five years
USER’S GUIDE
The TRANSITION Networks slide-in-module 10Mb/s Ethernet media converters, C/F-
SM-MM-05, which is designed to be installed in the TRANSITION Networks Media
Conversion Center, E-MCC-1600, connects 1300nM singlemode fiber-optic cable to
850nM multimode fiber-optic cable.
Compliance Information
UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
The F-SM-MM-05 media converter provides an ST fiber type RX (receive) and TX
(transmit) connector to 1300nM singlemode fiber-optic cable and an ST fiber type RX
and TX connector to 850nM multimode fiber-optic cable. Fiber’s low signal loss and
high resistance to radio frequency noise allow extended distances between devices
(up to 2 kilometers for multimode, up to 20 kilometers for singlemode).
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
The media converter functions in half-duplex mode or, when connected to devices
capable of full-duplex connectivity, in full-duplex mode.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Status LEDs
P(o)w(e)r Illuminated green LED indicates
European Regulations
Warning
connection to external AC power.
Link
Steady green LED indicates that fiber
link is connected properly.
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Copyright Restrictions
© 1998, 1999 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
33047.B
|